Fiat 500 Replacement Key Fob
If your remote key fob has stopped working, it might be time to replace the battery. However, if you replace the battery but it continues to stop working the issue could be elsewhere.
At United Locksmith, we specialize in the creation of new keys for classic cars. We have the tools and components needed for this job.
Dead Coin Battery
The most common reason why your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The battery for the coin cell in the key fob can be depleted quickly in the event that you don't use it frequently enough. If your remote starts to show signs of a loss of range, or has stopped functioning and the battery is not working, it could be dead.
Metal clips keep the battery in place inside the key fob. If the clips are not tightly secured, they could result in contact problems that will prevent your remote from receiving power. Use a flathead screwdriver to pry open the retaining clip and then remove the old battery. Be sure to choose an identical replacement battery kind of voltage, the same size, and specification as the original battery.
The key fob might be damaged or corroded by water exposure. Even a short bath in soapy water can harm the electronic chip in. Keep your key fob dry.
Water Damage
If your key fob isn't operating properly, it may be caused by water damage. The rubber seals on key fobs keep them from being damaged by a light drizzle or splash of water. However, it's important to keep the keys of your car away from the washing machine, ocean, and pool.
The key fob comes with an electronic chip that transmits a message to the immobilizer system of your car. The chip allows the 500 to start and lock. If it gets wet, however it won't function.
You can try cleaning your key fob's internal electronics with isopropyl alcohol or an electronic cleaner to determine if they are still good. However, it's best to get a replacement from a dealer instead of trying to fix the key fob that is submerged in salt water.
A replacement fob could cost you a bit however it's much less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You can also do it yourself by following only a few steps. Be sure to have the correct battery type before attempting to open your key fob. This task is far simpler than it appears and you can find step-by-step directions online for nearly every key fob for cars.
Faulty Chip
The chip inside the key fob is in direct communication with the immobiliser on your car to ensure that your vehicle will only start when correct keys are used. If the chip is damaged or damaged, your car won't start regardless of what you do.
Damage to the water or a dead cell battery are the two most frequent causes of defective chips. It is recommended to leave the repair to a professional locksmith, who will be able to replace the chip in a short time and at a reasonable cost.
If your key fob does not function after being exposed to clean rain or tap water, remove the battery. Wipe down the electronic component using an old towel. If the key fob still does not work, it is likely an issue with the chip and will require replacement.
Some people go to their dealer if they need an entirely new Fiat fob. However, this could be expensive. United Locksmith is the best option for you if need your Fiat key fob replaced at a reasonable cost. We have the tools and knowledge necessary to fix your Fiat key fob in a quick and professional way.
Faulty Receiver Module
Fiat key fobs send an electronic signal to the vehicle that will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are many reasons why the fob may stop working. This could be due to a dead battery, water damage, worn-out buttons as well as a receiver issue. signal interference, or an issue with the chip.
If the fob has been in a pocket that has endured extreme trauma, like falling on hard floor or getting washed in a wash machine the fob may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine original key and not any other.
You'll have to replace the fob in case this occurs. website can handle the entire key replacement process including programming a new key for your 500. They can even provide you with a clone fob that works exactly like the original (and costs just one-third of the price).